Another helpful mode of the Tamper Data extension is to graph the output of the page load data. TamperData扩展有一种有用的模式,将页面装载数据的输出绘制成图形。
Or under same output power and load, the power supply voltage of the former is only one half of that for the latter. 或者,在输出功率和负载相同条件下,前者的电源电压仅为后者的一半。
It operates both in current mode at high output load and in pulse frequency modulation ( PFM) at light load to reduce the power dissipation. 它在重载下工作于电流控制模式,轻载下工作于脉冲频率调制(PFM)模式来降低功耗。
Influence of the Transmitter Output Network Load Change on Operation Status 发射机输出网络负载变化对工作状态的影响
Based on the multi-scenario probability method, the uncertain factors, such as wind farm power output, load change and economy, are described by scenario analysis and probability calculation. 应用多场景概率的方法,将风电场的输出功率和在电网规划中涉及到的负荷变化、经济等不确定性因素,以场景分析和概率计算的方式加以描述。
In this way, the bottleneck may appear in the VOD system with single server, eg. input/ output load ability and store ability, can be distributed in the network, and enable it to face mass users and offer high-quality video on demand service effectively. 这样,对于单机型的视频点播系统设计中可能出现的瓶颈,例如输入/输出负载能力和存储能力,就可以分布到网络中,使其能有效地面向大用户群提供高质量的视频点播服务。
The impedance having between power supply input and output load, connect feed back control network autoregulati0on tune resistance, for stabilized voltage, it is series regulator. 在电源的输入与负载之间串连一只阻抗器,通过接入反馈控制网络自动调整阻抗器的电阻值,来稳定输出电压,就形成了串连式稳压器。
Lastly, according to creating prototype system and designing four comparing experiments, it gets the experiment statistical data, and makes a conclusion that this routing protocol algorithm has a better performance on one way delay, output, load balance and etc. 最后通过建立原型系统并设计四个对比实验,得出实验统计数据,定量地测定了该路由协议算法在单程路径延迟、吞吐量和负载平衡等方面所具有的优越性。
The curves of output power vs. load resistance 、 work efficiency vs. load resistance and exergy efficiency vs. load resistance are obtain at different cases, and load resistance is constant, the curves of work efficiency vs. 实验得到了不同工况下输出功率,工作效率,火用效率随负载电阻的变化曲线,以及在负载电阻一定的情况下,工作效率、火用效率随温差的变化曲线。
Experimental results prove that the proposed strategy can make the inverter maintaining symmetrical output voltages under unbalanced load. 实验结果证明了该控制方案能使逆变器在不平衡负载下保持三相输出电压波形的对称性。
( 0,9) mode is stimulated inside the stator. Under 60 V driving voltage and 40.2 kHz resonant frequency, its velocity free of load is 28 r/ min and maximum output load is 0.07 N · m. 定子采用(0,9)振动模式,在电压有效值为60V、频率40.2kHz下其空载转速为28r/min,最大输出载荷0.07Nm。
After testing the endurable voltage and current values of various rated current of IGBT modules, the equipment with the suitable module could generates below 200 Hz of 300 A transient current pulse when the output load is in 2 Ω and 3 μ H. 实验测试了不同额定电流IGBT的耐迅变电流冲击参数,当线路输出负载为2Ω、3μH时,可以得到200Hz以下近300A迅变脉冲。
This paper analyses the effects of several factors on the power output, including load coefficient, voltage drop in electrode boundary layer, electrode resistance, axial and transverse leakage current and finite segmentation of electrodes. 本文分析负载系教、电极边界层电压降、电极电阻、轴向与横向漏电以及电极有限分段对输出功率的影响。
Research on the Output Capability of Load Cell and the Offset Circuit 负荷传感器补偿电路及电特性研究
The signal source with a close loop DC feedback and a PID controller is able to keep a constant current output under different load conditions which enables the developed system suitable for a very wide range of grounding impendence. 在恒流信号电源部分控制系统的设计中采用了闭环PID直流反馈控制和引入了非线性环节,因此能在负载大范围波动的情况下保持注入电流频率恒定和幅值恒定,可靠性高。
Method of Linearization for Output of Load Cells 力传感器输出曲线的线性化处理
The negative effects of PWM Inverter-fed motor drive system are analyzed in the paper. An optimal design method of the inverter output filter considering load effects is proposed. 对逆变器驱动感应电机时的负面效应进行了分析,提出了一种考虑负载效应的逆变器输出滤波器优化设计方法。
For the cell working range ascertainment, the algorithm determines the maximum output load, the minimum output load, the maximum input signal slope and the minimum input signal slope; 通过计算单元在各测试状态下的最大、最小输出负载,输入信号的最大、最小斜率,算法能精确计算单元的工作曲面范围;
From January to April, it is oxygen-enriched in the water bottom, therefore, the input of endogenous of nitrogen outweighs the output and the load appears positive; 1~4月水体底层富氧,氮的内源输入大于输出,内源负荷呈正值,其他月份呈负值。
And no change the output voltage and load, adjust the output duty cycle to regulate the average size of the circuit. 且在输出电压不变和负载不变的情况下,实现用占空比来调节输出平均电流的大小。
In practice, the output whose load needs stable voltage critically and the largest power is selected as main output. And the outputs, whose load allow voltage to vary in an acceptable range, are selected as auxiliary outputs. 在实际应用中一般是选取对电压要求较为苛刻且功率最大的供电回路作为主输出路,允许电压在一定范围内波动的负载采用输助输出供电。
Super-pressure hydraulic pressure automatic reverse pressure intensifier is one kind of ultrahigh voltage hydraulic pressure increases the strength installment, may effectively reduce the pressurizing unit the external dimensions, and enhancement output load strength. 超高压液压自动换向增器是一种超高压液压增力装置,可以有效地减小增力装置的外形尺寸,并提高输出负载力。
Analyzed the double module pulse power characteristics, energy-storage simulation analysis found that superconducting magnets discharge the output waveform with load is concerned, not only with the connection mode and switch delay involved. 在单模块的基础上分析了双模块储能脉冲功率的特性,仿真分析发现超导磁体放电输出波形不仅与负载有关系,也与其连接方式及开关延时有关。
This paper uses it in asynchronous motor with light load, makes the electrical output torque and load match through regulating the motor terminal voltage. So it can enhance efficiency, achieve energy-saving purposes. 本文将其应用在轻载时的异步电机上,通过调节电机的端电压使电机输出转矩与负载相匹配,从而提高效率,达到节能的目的。
Aiming at the frequency characteristic of output load for common wireless parallel system, the dynamic coefficient droop method of active power is introduced to eliminate the system steady error of output frequency. Furthermore, the simulation verifies the theory analysis successfully. 6. 针对常规无互联线并联系统的输出负载频率特性,采用有功功率动态变系数下垂法,来消除系统稳态输出频率误差,并在理论分析基础上,成功完成了仿真实验。
However, permanent magnet synchronous generator is limited by the difficulty of adjusting output voltage. Vehicle power systems requires steady output voltage when load changes and temperature changes, in which hybrid excitation generator can solve this problem. 但是永磁同步发电机的输出电压很难调节,而车载电源系统要求在负载变化,温度变化的情况下仍能提供稳定的电压,使永磁同步电机的应用受到限制。
Adopting steam pressure feed-forward will enable the control system to perceive the steam pressure changes, and timely adjust the mill output to sustain load. 采用蒸汽压力前馈,将能使控制系统提前感知蒸汽压力的变化,及时调整制粉出力以维持负荷。
There is a certain similarity between the photovoltaic output and the load fluctuation. 光伏发电输出功率与日负荷波动具有一定的相似性。
The output variation of the power shows it really does work for some following advantages: wide modulation range, quick response, almost no wave distortion, constant output with non-linear load. 电源输出结果显示,研制成的电源具有调节范围大,动态响应速度快,输出波形失真小,带非线性负载能力强等诸多优点。